The customization for bicycle accessories will be designed as per demand and their liking.
As stated by GCN Tech,¨ 3D printing has been around for a number of years now, but 3D printed bike frames have always been a bit hit and miss…until now! Ollie was lucky enough to visit the workshop of legendary frame builder, Tom Sturdy, to check out his latest creation: A custom titanium bike using 3D printed lugs. This frame is an amazing feat of engineering, and it might just be one of the best looking bikes we’ve ever seen.¨
On basis of Autoevolution´s article,¨ To make these components, 3D printers lay “down 3500 layers of titanium powder and is melted in place by four lasers ono a titanium build plate.” This differs from component to component and manufacturer.¨
By continuing to use the site, you agree to the use of cookies. more information
The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.
June 18, 2021 at 7:23 pm
Holy cow!