Month: November 2019

Fans of the day *

Posted on Updated on

Fans of the day *

Advertisements

Risk factors for osteoporosis and treatment adherence with osteoporosis medications

Posted on Updated on

According to New York-Presbyterian Hospital Endocrinology,” She has published widely in the medical literature and is co-editor of the book, The Bone and Mineral Manual.Dr. Siris served as the Medical Director of NORA, the National Osteoporosis Risk Assessment, a public health initiative and longitudinal study of osteoporosis that included over 200,000 postmenopausal women in the US. Most recently her research activity has focused both on risk factors for osteoporosis and treatment adherence with osteoporosis medications. Siris has been interviewed frequently on both television and radio and is often quoted in print media regarding osteoporosis.”

 

The Osteoporosis Manual: Prevention, Diagnosis, and Management

Ethel S. Siris, MD

 

3-D Printed heart model and surgeons information

Posted on Updated on

According to NewYork-Presbyterian,” Dr. Farooqi went on to complete an advanced imaging fellowship at Kravis Children’s Hospital, Icahn School of Medicine at Mount Sinai. Dr. Farooqi’s research focuses on the use of 3D printed and digital cardiac models to improve care for patients with congenital heart disease. She was granted the Glorney Raisbeck Fellowship Award by the New York Academy of Medicine to identify the optimal cardiac MRI sequences in creating 3D models. Prior to joining Columbia, Dr. Farooqi was a full-time faculty member at the Rutgers New Jersey Medical School for two years and led the pediatric cardiology service for the University Hospital in Newark.”

 

3-D PRINTED HEART MODELS GIVE SURGEONS VITAL INFORMATION ABOUT A HEART’S ANATOMY

Rapid Prototyping in Cardiac Disease: 3D Printing the Heart 

Kanwal M. Farooqi, MD

 

NC STATE STUDENTS LAUNCH 3D PRINTING OF PROSTHETIC DEVICES

Posted on Updated on

NC State students launch 3D printing of prosthetic devices.
According to Helping Hand Project President Griffin Drye said, “A general prosthetic might cost between $10,000-20,000, and a kid grows out of that in six months. Each device we print costs between $50-100 to actually produce.”

NC STATE STUDENTS LAUNCH GOFUNDME TO HELP FUND 3D PRINTING OF PROSTHETIC DEVICES FOR CHILDREN IN NEED

The Helping Hand Project at NC State

Artillery Sidewinder X1 3D Printer 2019 review

Posted on Updated on

From Comments and Amazon.com review Q and A,

1
Is this the version 4 printer?

It is the newest version.
By LOYLOV SELLER on October 8, 2019
Yes, it is the newest version.
By LOYLOV SELLER on September 30, 2019
yeah it is
By nbenci on September 30, 2019

 2

Electro DIY
Electro DIY
5 days ago
Amazing 3D printer for hobbyists, thanks for the review 👍👍

3

Nith ish
5 days ago
Groot looks so cute… ❤❤❤

4

Asim Latif
1 day ago
Its output is so smooth

5

Lucas Agazzani
3 days ago
Hey, I was wondering if there is a possibility to make a Thermos with 3d printing?
Engineering Juice
Engineering Juice
58 minutes ago
Yes, you can.
Lucas Agazzani
Lucas Agazzani
28 minutes ago
@Engineering Juice and the vacuum will work just fine, right, because it is a poor conductor?
Engineering Juice
Engineering Juice
24 minutes ago
@Lucas Agazzani It depends on the material you are printkng with, as well as your design and tolerances.
Engineering Juice
Engineering Juice
23 minutes ago
@Lucas Agazzani I have a Youtube tutorial on my channel where I design a water bottle. Maybe that can help you